What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
14.06.2025 06:20

Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
A fuse is a non-resetable over current circuit protector.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
Why is there no great temptress figure in any of Tolkien’s major works?
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
How do you handle family members who ask for handouts?
At least they know the answer if they wanted it.
The third is lightning and “how it gets conducted into a home.”
He then asserts :
but this device (an Inductor) … impedes the rapid changes in the current.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
It seems Mohan does not understand the difference between a comment and an Answer.
2024–10–14 [Omar Gharbi Omar Gharbi ]
so, what happens?
The bolt then partially travels down the line to your home.
Do people have to be a pastor to baptize?
a photo is worth a thousand words.
There are two important concepts here.
He then describes the function of a fuse.
So, the voltage could go up to 500 volts, and the fuse will not open up.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
I post the exact comment here.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Barnstars:
The MOV will conduct when the voltage exceeds 50% of line voltage.
One is “what exactly is in a ‘surge protector’ ? ”
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Edit 2024–10.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
This is 'the assistant's answer'
An AC voltage/ current source, and an ac inductive load.
What are you struggling with in your life? What would you like to have instead?
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
but I think this circuit , shows a few more pieces.
[image of Common-mode choke]
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Here is a simplified AC power diagram.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Can you tell me something about yourself?
A circuit breaker is similar, but is resettable.
But it can get overloaded, and no longer works.
One
This is where this question deviates from being a 'generic' question, and becomes more specific.
[old diagram got deleted by accident]
eight
What is lightning?
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
These devices are installed between the “hot” and “neutral” and protective ground.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
nine
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
what exactly is a ‘surge’ protector?
It also is a device that limits the change in current flow.
Now when you have a certain ac resistance, then a current flows in a loop.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
The other is “what does a “fuse” do?”
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
He then describes Rainy Season and Lightning.
At one ohm, the resistor has a maximum of 1 watt power.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
(Dc diagram shown, AC is similar).
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
2024–10–16 [ OO OLAOYE OYEBODE ]
Upvotes:
First Sentence:
the problem then depends on "how fast does the fuse operate?".
This is where the MOV conducts again, and dissipated the energy.
What does a fuse do?
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
There are three different concepts here that are getting confused.
In schematic diagrams this is the symbol for a fuse:
For this case there are devices called Metal oxide varistors (MOV).
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
This device then solves the entire problem.
These are simplified answers to the original question, and does not change anything I wrote above.
2024–10–10[John johnson John Johnson ]
Because the load is inductive, the current lags the voltage.(by a bit).
This one hit behind the barn.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
But… the neutral is now “floating” because of the 1 ohm resistance.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.